Shimo 2•VPN started, no traffic, tun0 interface not pingable
-
tani ~ $ ifconfig tun0
ifconfig: interface tun0 does not exist
tani ~ $ ifconfig tun0
tun0: flags=8851 mtu 1412
inet 10.100.223.18 --> 10.100.223.18 netmask 0xffffffff
open (pid 1652)
tani ~ $ route get 10.49.11.252
route to: 10.49.11.252
destination: 10.49.11.0
mask: 255.255.255.0
gateway: 10.100.223.18
interface: tun0
flags:
recvpipe sendpipe ssthresh rtt,msec rttvar hopcount mtu expire
0 0 0 0 0 0 1412 0
tani ~ $ ping 10.100.223.18
PING 10.100.223.18 (10.100.223.18): 56 data bytes
Request timeout for icmp_seq 0
Request timeout for icmp_seq 1
Request timeout for icmp_seq 2
^C
--- 10.100.223.18 ping statistics ---
4 packets transmitted, 0 packets received, 100.0% packet loss
tani ~ $ ping 10.49.11.252
PING 10.49.11.252 (10.49.11.252): 56 data bytes
Request timeout for icmp_seq 0
Request timeout for icmp_seq 1
Request timeout for icmp_seq 2
^C
--- 10.49.11.252 ping statistics ---
4 packets transmitted, 0 packets received, 100.0% packet loss
This same configuration was working fine a week or 2 ago.
The same config works with vpnc on freebsd and linux.
I can not for the life of me figure out what is going on here…
Any help? -
No help on this? I am out of my VPN connection...
-
Reproduced on someone else's computer. Both running 10.6.2.
-
So you did not change anything since Shimo worked the last time? Any updates installed?
Fabian
